![Multiple passthrough mac address](https://kumkoniak.com/114.png)
![multiple passthrough mac address multiple passthrough mac address](https://i0.wp.com/benisnous.com/wp-content/uploads/2020/09/How-to-check-MAC-Address-Physical-Address-IP.jpg)
Router will automatically detect MAC address of the first received packet and use it for the Passthrough. Some modems support multiple APN where you can pass the traffic from each APN to a specific router interface. The LTE Passthrough modem can pass both IPv4 and IPv6 addresses if that is supported by modem. In this configuration the router will not get IP configuration from the modem. In this case modem firmware is responsible for the IP configuration and router is used only to configure modem settings - APN, Network Technologies and IP-Type. Starting from RouterOS v6.41 some LTE interfaces support LTE Passthrough feature where the IP configuration is applied directly to the client device. Manufacturer: Huawei Technologies Co., Ltd. It is possible to scan LTE interfaces with /interface lte scan commandĪvailable read only > /interface lte info lte1 once Username used if any of the authentication protocols are active If set to yes, uses DNS recieved from LTE interface If set to yes, uses network provided APN. Parameter is available starting from RouterOS v7 and used only for MBIM modems. Password used if any of the authentication protocols are active If set to auto, then will learn MAC from first packet Interface to passthrough IP configuration (activates passthrough)
![multiple passthrough mac address multiple passthrough mac address](https://i0.wp.com/passthroughpo.st/wp-content/uploads/2019/06/catalina-graphics-crop.png)
Interface on which to advertise IPv6 prefix Ip-type ( ipv4 | ipv4-ipv6 | ipv6 Default: ) LTE route by default is with distance 2 to prefer wired routes over LTE Sets distance value applied to auto created default route, if add-default-route is also selected. Whether to add default route to forward all traffic over the LTE interface.Īuthentication ( pap | chap | none Default: none)Īllowed protocol to use for authenticationĭefault-route-distance ( integer Default: 2) PLMN codesĪll network related settings are moved under profiles, starting from RouterOS 6.41 Used to lock device to specific operator full PLMN number is used for lock consisting from MCC+MNC. Select/force mode for LTE interface to operate with Network-mode ( 3g | gsm | lte Default: 3g,gsm,lte) Max packet size that LTE interface will be able to send without packet fragmentation. Modem init string (AT command that will be executed at modem startup) Media Access Control number of an interface. Which APN profile to use for this interfaceįrequency band used in communication LTE Bands and bandwidths Some modems, that do not fully support this feature, will connect to the network but will not establish an IP data connection with allow-roaming set to no. Enable data roaming for connecting to other countries data-providers.
![Multiple passthrough mac address](https://kumkoniak.com/114.png)